Spot paint on metal and composite surfaces (SE-P-17775)

Purpose

The overall purpose of this course is to enable the participant to achieve knowledge, skills and attitudes regarding Epoxy safety and perform a repair whit 2 component paint on steel and composite.

Objectives

Knowledge about the use of Safety Data Sheets. (SDS)
Knowledge about working safe with primer, epoxy resins and isocyanides by showing correct behavior in the practical exercises.
Knowledge of the damaged level.
Demonstrate how to work in a safe way mixing and handling 2-component material.
Demonstrate the ability to use correct personal protection equipment (PPE) during the practical exercises.
Demonstrate how to clean a surface.
Demonstrate how to apply primer and paint on steel or composite.
Demonstrate how a coating is tested with the use of microns gauge.
Demonstrate the correct using a sander and a grinder.
Demonstrate marking a repair.
Demonstrate how to use a hygrometer, thermometer, model 319 T dew point, IR thermometer wet film thickness guage.
Demonstrate how to carry out a repair according to relevant Work Instructions. (WI)
Demonstrate how to document the repair with the use of (Photo card, check lists, etc.)
Demonstrate how to perform correct paint repair during the practical exercises.
Competencies
Upon completion of the course the participants have obtained the following qualification:
To execute repairs according to relevant work Instructions and checklists
Work instruction
  • - D1197746 Repair paint on steel onsite
  • - D1197678 Application of topcoat
Checklists CH
  • - D1204055 Repair paint on steel onsite
  • - D1459277 Application of topcoat

Contents

Make small repairs with sport paint on steel and composite.
  • - Personal safety working with epoxy resins and isocyanates
  • - Correct personal protective equipment (PPE)
  • - Material knowledge regarding paint, primer, topcoat
  • - Grinder and sander
  • - Mark up of damage
  • - Applying primer
  • - Mixing paint
  • - Painting on steel and composite
  • - Knowledge for hygrometer, thermometer, model 319 T dew point, IR thermometer, microns gauge and wet film thickness gauge
  • - Take wet film thickness gauge
  • - Use of photo card
  • - fill in checklist

Who should attend?

SGRE employees and subcontractors. Working whit spot paint on steel and composite.

Prerequisites

Personal Safety when working with Epoxy and Isocyanates

Notes


Validity
No expiry

Course duration

2  days

Price

 

Cancellation fee

100 percent of course fee after 30 days before the start of course.

Export control

AL-Number: N
ECCN: EAR99

Course dates

The following dates are available
Location Date Free Seats Lang.    
Book on waitinglist        

Contact person:

Global Training Customer Engagement
Phone:  +86  2223907838
E-Mail:  GTCE@siemensgamesa.com

Address:

Global Training Customer Engagement
No.8th, the 4th Haitai Chuangxin Road Huayuan Indu
300384 TIANJIN
China
Phone:  +86  2223907838